3D printed Mini Torso Extension Unit.

COMPATIBILITY
This accessory component is compatible with ONLY Armiger class Knights. Please view the other listing for parts related to full sized knights.
This part does not replace any existing component, but rather is sandwiched between the legs and torso of the model to make it taller.

CLEANING INSTRUCTIONS
Add some drops of dish soap to a cup of warm water and stir. Place the component(s) into the soapy water and leave to soak for 5-10 minutes, then thoroughly scrub each piece with an OLD toothbrush. Rinse component(s) thoroughly and allow to dry.

ATTACHING INSTRUCTIONS
Glue the extender to the bottom of the torso, so the rear piston ends sandwich the cylindrical detail near the back of the model.



DISCLAIMERS
This web store is completely unofficial, and its contents are in no way endorsed, or affiliated with Games Workshop Limited. Imperial Knight Dominus Valiant, Imperial Knight Dominus Castellan, Imperial Knight Titan, Imperial Knight Warden, Imperial Knight Paladin, Imperial Knight Errant, Imperial Knight Crusader, Imperial Knight Gallant, Armiger Warglaive, Titanicus and the Warhammer 40,000 name are either ® or ™, and/or © Games Workshop Limited, variably registered around the world. Photographs of existing miniature kits are used only to show scale and compatibility with the accessories found on this page. Used without permission. No challenge to their status intended. All Rights Reserved to their respective owners.
Choking hazard. Not meant for children 18 years or younger.
These custom designed conversion components will arrive unpainted.